Elgin Window Pros provides professional french doors in Elgin, IL for residential and commercial properties across the Fox River valley in Kane County. French doors swing, and in a climate that drifts snow that single fact decides most of the specification. Which way they swing, what the sill looks like and where the hardware lives all follow from it.
Get the swing wrong and you will be reminded of it every winter for twenty years. We install them in-swing nearly every time here. An out-swing pair looks tidy and sheds water beautifully, and then in February a drift builds against the exterior face and the door will not open. The hinges also sit outside, which is a question worth asking on a rear elevation.
Out-swing has its place under a deep covered porch where drift cannot reach the leaves. In-swing costs floor space. A pair of thirty-inch leaves sweeps a semicircle into the room, and in a small dining room that arc eats exactly the space you were going to put a chair in. Lay it out on the floor with tape before committing, not on a plan sheet.
Sealing a pair is harder than sealing a single door because there is no jamb down the middle. What closes that gap is the astragal, a vertical member on one leaf that the other shuts against, and its weatherstrip is the part that wears out. We specify a replaceable astragal seal rather than one molded into the leaf itself.
The astragal also carries the strike for the active leaf, so a worn one shows up as a door that no longer latches cleanly. Flush bolts at head and sill hold the standing leaf shut, and those bolts are the second wear point. Surface bolts are simple to service and frankly ugly; concealed bolts look correct and are a nuisance to adjust. We show you both operating before you choose, because you will handle them every day.
Whichever you choose, the bolt has to seat fully into the head and the sill rather than into a shallow dimple in the weatherstrip. Multi-point hardware is the upgrade worth having. One throw at the handle pulls the leaf against its weatherstrip at the head, the middle and the sill simultaneously, and it takes the twist out of a tall door. Across an eighty-inch leaf that is the difference between a door that seals and one that whistles.
It also spreads the load across the frame instead of concentrating it on a single latch point, which is why the leaves stay flat. If a room cannot afford the swing, we will tell you to buy a slider rather than squeeze a narrow pair into the opening. A pair of twenty-four-inch leaves is an awkward object, too narrow to move furniture through and too wide to seal well, and it satisfies nobody in the end.
Glazing follows the same hazardous-location rule as any exterior door, so the lites arrive tempered and permanently marked, and we check for a sidelight sitting inside the swing arc before anything is ordered. Screens are the other thing to settle early, since a retractable screen for a hinged pair is a different order and a different price.
Our licensed and insured team brings the right materials and equipment to every job — pan flashing carried a full six inches up both jamb legs, hand-packed mineral wool filling an emptied sash-weight pocket, brickmould and exterior casing left undisturbed on a pocket install, an NFRC label left adhered to the glass and faced outward for final, backer rod bedded behind a tooled sealant joint at the exterior reveal, compression-seal casement hardware bearing on a continuous jamb gasket — and backs the work with a written workmanship warranty. We serve Elgin and nearby communities including South Elgin, St. Charles, Geneva, Batavia.
What We Handle
Everything our french doors in Elgin covers
One crew, one point of contact, and the full range of french doors work in Elgin, IL. If it is on this list we do it in house rather than handing it to a subcontractor:
- french doors
- french patio doors
- double french doors
- in swing french doors
- french door astragal
- multi point lock doors
- french door install
- french door cost
- flush bolt hardware
- french door weatherstrip
- hinged patio doors
- french door glass
- french door repair
- interior french doors
- french door replacement
- french door quote
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Elgin services.
Materials, equipment and how we do french doors
The difference between french doors that lasts and french doors that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with pan flashing carried a full six inches up both jamb legs, hand-packed mineral wool filling an emptied sash-weight pocket, brickmould and exterior casing left undisturbed on a pocket install, an NFRC label left adhered to the glass and faced outward for final, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Elgin job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of window work in the Fox River valley in Kane County means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do french doors outside Elgin
Elgin Window Pros covers Elgin and the surrounding communities of the Fox River valley in Kane County. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- French Doors in South Elgin, IL — Kane County, population 23,865
- French Doors in St. Charles, IL — Kane County, part in DuPage County, population 33,081
- French Doors in Geneva, IL — Kane County, population 21,393
- French Doors in Batavia, IL — Kane County, population 26,098
- French Doors in Carpentersville, IL — Kane County, population 37,983
- French Doors in West Dundee, IL — Kane County, population 7,686
Start on the Elgin Window Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Elgin Chooses Elgin Window Pros
- ✓Every opening on our quote is marked insert or full replacement before you sign, because that one word decides the flashing, the permit route and roughly a third of the price.
- ✓Where a full replacement is going in, the pan flashing is a priced line item you can point at, not a detail buried behind trim that nobody ever checks.
- ✓We pull the permit and book the final ourselves, and we leave every label stuck to the glass and turned outward so the inspector can read it from the sidewalk.
- ✓We ask what year the house was built before we price a single window, because a boxed weight pocket and a modern jamb liner are two entirely different jobs.
The standards behind french doors
Quality here is not a matter of opinion — it is written down. The french doors work we do in Elgin follows published industry standards: NFRC sets the U-factor and SHGC ratings on every window label, and ENERGY STAR defines the efficiency thresholds by climate zone. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every french doors project in Elgin gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free french doors free estimate in Elgin, or request a quote and we'll get right back to you.